Floriani No Show Mesh Tutorial
To use Floriani No show Nylon Mesh:
Cut a piece of the stabilizer at least one inch larger than the hoop size you are planning to use.
Hoop the stabilizer to the back of the garment.
Place the embroidery frame on to the machine. Complete the layout and centering of the design.
Important! If the design is denser than 6,000 stitches or if it is a poorly digitized design (too many stitches for designs size),"float" one layer of Floriani Medium Tearaway between the hoop and the bed of the machine for each additional 8,000 stitches for added support! After the design is complete the tear away can be removed leaving just the soft mesh against the skin.
After the design is complete, remove the garment from the machine and embroidery hoop. Trim the stabilizer as close to the design as possible.
*Tip! If embroidering knit, don't forget to use topping!
*Tip! To get extra support on large or problem designs without adding bulk, try crossing two layers of the mesh when hooping, one at 90°and the other at 45°. This will offer a tremendous amount of stabilization without stiffness.
Did you know that your Floriani No Show Nylon Mesh is a great way to create free standing embroidery designs that you can adhere or appliqué to any surface? Think of the possibilities! Now you can have your beautiful embroideries on the most delicate fabrics or the oddest or most difficult foundations! Click on the link below to check out the projects page for this exciting technique.
Floriani's No Show Mesh Product Identity